STRUCTURAL FEATURES

Compressor: Hermetic inverter (1+i) scroll compressor with thermal protection and crankcase heater.
Continuous capacity regulation at partial loads.
Evaporator: It is completed with close cell stainless steel plates with polyurethane foam insulation and water flow differential pressure switch.
Condenser: Micro channels or finned coil that is developed with copper pipes and aluminium fins depending on the models and dimensions.
Fan: Electrical axial fans with external rotor, equipped with built-in thermal protection and protection grills.
Control: Microprocessor control with the feature of Adaptive Function Plus.
Structure: Made of polyester powder paint coated and galvanized painted steel sheet.

STANDARD FEATURES

•Circuit disconnecting switches of fan and compressor.
•High and low pressure gauge.
•Master/slave control up to parallel connected 4 units.
•Time-card.

VERSIONS

• TCAITY: High efficiency version, only cooling (T).
• TCAIQY: Super silenced version, Only cooling (Q).
• THAITY: Heat pump unit.
• THAIQY: Super silenced version, heat pump unit.

FACTORY FITTED ACCESSORIES

• Single or double pump. 1 main and 1 backup applications in double pump options.
Standard and high pressure versions of pumps are optional.
• Tank and Pump Unit: Accumulation tank up to 230-440 litres depending on the model, with expansion tank, manual air relief valve, safety valve and water side pressure gauge. Low or high pressure versions of those pumps are available.
• Pump control with variable flow (VPF: Variable Primary Flow).
• Partial heat recovery option (Desuperheater).
• Full heat (100%) recovery option.
• Condensation control through fans with EC motor. (standard for 270-2100).
• Condensation control through over pressure fans (T version).
• Power factor correction capacitor (Cosφ > 0,94).
• Forced power consumption limit.
• Forced noise limit.
• Soft starter.
• Acoustical insulator for the compressor.
• Acoustical insulation.
• Suction and compression valves of cooling circuit.
• Refrigerant leakage detector.
• High and low pressure gauges for the refrigerant circuit.
• Double safety valves.
• Metal filters or coil protection grills.
• Epoxy coated condenser with micro channels.
• Copper/copper or copper/aluminium pre painted aluminium coils.
• Minimum/maximum power supply control.
• Digital input for double set point.
• Set point shift (4-20 mA analogue signal).
• Evaporator anti-freezing heater, electrical panel, accumulation tank, electric pumps and heat exchangers for heat recovery, if applicable.
• Interfaces for serial communication with other devices.
• Rubber anti-vibration mouths.

SEPARATELY SUPPLIED ACCESSORIES

• Remote controller with display.
• Thermostat with display.
• Control devices for monitoring and remote management of the device.
• Sequencer for integrated management of multiple chillers.